C.A. Technologies 2.5 Gallon Paint Pressure Tank – Bottom Outlet

The 2.5 gallon, non-ASME, bottom outlet pressure tank (pressure pot) from C.A. Technologies come configured with either single (51-211) or dual regulators (51-212) and No pneumatic agitation (mixer). The tank is constructed of heavy gage steel with a baked on enamel finish and has wheels for maneuverability or optional stationary feet.

Specifications:

• Bottom outlet tank with a 3/4” NPT female fluid outlet
• ¼” NPS male air inlet & outlet
• Tank inside diameter is 10.5”
• Tank inside depth is 8.75”
• Single or dual regulator options
• No pneumatic agitation (mixer)
• Includes casters for maneuverability
• Maximum pressure rating of 80psi
• Safety relief valve
• Vent valve

*(Please note that replacement liners are not available for bottom outlet tanks. In addition, Top Outlet pressure tanks are available. Please refer to item numbers 51-201 (single regulator) or 51-202 (dual regulators) for similar tank configurations in a top outlet tank).

2.5 Gallon Paint Pressure Tank – Bottom Outlet (51-211 & 51-212) Part Sheet

NOTICE: We want to make prospective paint pressure tank customers aware of corrosion issues using water base coatings, and especially water solutions in steel baked on enamel coated pressure tanks, or aluminum 2 quart cups.

Coatings and solutions contained in these closed steel baked on enamel coated tanks will develop rust over time as the result of the 100% humidity where the film is broken around the gasket ring welds, plated steel fittings, and underside of the lid.  When pressure tanks are in everyday use of coatings and solutions contain water we recommend stainless steel pressure tanks.

Aluminum 2 quart cups can also develop rust (white powder) when coatings and solutions are stored in the cup for an extended amount of time. However this corrosion does not occur when the cup is cleaned and air-dried after each use.